Daewoo Nexia

Since 1994 of release

Repair and car operation

17.13. Brake disks CHECK РАЗНОТОЛЩИННОСТИ OF THE DISK

To measure

PERFORMANCE ORDER

1. It is necessary to measure a thickness in four or more places on a disk circle. All measurements are spent on identical distance from external edge of a disk. 2. If the thickness of a disk measured in various places differs more, than on 0,01 mm, at braking pulsations of effort on a brake pedal will be felt, and also vibration передка the car is possible. The worn out disk, not satisfying to this requirement, it is necessary перешлифовать or to replace new.

CHECK OF FACE PALPATION OF THE DISK

AND. THE MEASURING INDICATOR 10. BRAKE СКОБА (THE FORWARD RIGHT WHEEL) 16. THE BRAKE DISK

PERFORMANCE ORDER

1. To include a neutral in transmissions. 2. To lift the car. 3. To remove forward wheels. To mark position of wheels concerning naves. 4. To fix a brake disk on a nave two wheel bolts. 5. To establish on brake скобу the measuring indicator. 6. To establish probe the indicator on distance about 10 mm from external edge of a disk. Щуп it should be perpendicular planes of a disk and it is pressed to a disk by small effort. Supposed face palpation of a disk no more than 0,1 mm. If face palpation exceeds admissible value, it is necessary to check up cleanliness and density прилегания the interfaced surfaces of a disk and a nave, and also absence задиров on a surface of a friction of a disk. 7. To remove the indicator. 8. To turn away wheel bolts. 9. To establish forward wheels and to tighten fixing bolts the moment of 90 Nanometers. 10. To lower the car.