Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
- Топлевная and exhaust systems
   5.2. System of injection of fuel
   5.3. Modes of functioning of system
   - 5.4. The basic knots of system
      5.4.1. A fuel tank, the pump and pipelines
      5.4.2. The distributive fuel pipeline
      5.4.3. Fuel atomizers
      5.4.4. A regulator of pressure of fuel
      - 5.4.5. The case throttle заслонки
         5.4.5.1. The idling valve
         5.4.5.2. The gauge of position throttle заслонки (ДДЗ)
      5.4.6. The relay of pressure of oil
      5.4.7. The relay of inclusion of the fuel pump
      5.4.8. Check of giving of the fuel pump
      5.4.9. A fuel tank
      5.4.10. An accelerator pedal
      5.4.11. The fuel filter
      5.4.12. The fuel pump
      5.4.13. Dump of pressure of fuel in system
      5.4.14. The distributive fuel pipeline
      5.4.15. Fuel atomizers
      5.4.16. A regulator of pressure of fuel
      5.4.17. The case throttle заслонки
      5.4.18. The gauge of position throttle заслонки (ДДЗ)
      5.4.19. The idling valve (КХХ)
      5.4.20. Replacement of the case throttle заслонки
      5.4.21. System of compulsory ventilation картера (СПВК)
      5.4.22. Check of functioning of the valve of ventilation картера (КВК)
      5.4.23. System of release of the fulfilled gases
      5.4.24. Katalitichesky neutralizer
      5.4.25. A reception exhaust pipe and каталитический neutralizer
      5.4.26. The forward muffler with an intermediate exhaust pipe
      5.4.27. The back muffler with an exhaust pipe
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

5.4.5.2. The gauge of position throttle заслонки (ДДЗ)
THE GENERAL DATA

The gauge of position throttle заслонки

1. THE GAUGE OF POSITION THROTTLE 3АСЛОНКИ
2. THE FIXING SCREW WITH THE WASHER

ДДЗ it is established on the case throttle заслонки from an opposite side from the drive lever заслонки. ДДЗ it is intended for transformation of an angle of rotation заслонки in an electric signal which moves on input ECU. Position throttle заслонки is considered ECU at definition of duration of a phase of opening of fuel atomizers. At full opening throttle заслонки ECU provides the maximum giving of fuel through all four atomizers, increasing a phase of opening of atomizers or raising frequency of operating impulses. ДЦЗ it is connected to the platen throttle заслонки, movement to which is transferred from an accelerator pedal.

For transformation of an angle of rotation throttle заслонки in an electric signal the potentiometer which 5 V.Pri turn заслонки eat from ECU basic pressure is used electric resistance of a potentiometer and pressure of target signal ДЦЗ changes. On size of a signal of DTSZ ECU counts current position throttle заслонки.