Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
- Топлевная and exhaust systems
   5.2. System of injection of fuel
   5.3. Modes of functioning of system
   - 5.4. The basic knots of system
      5.4.1. A fuel tank, the pump and pipelines
      5.4.2. The distributive fuel pipeline
      5.4.3. Fuel atomizers
      5.4.4. A regulator of pressure of fuel
      + 5.4.5. The case throttle заслонки
      5.4.6. The relay of pressure of oil
      5.4.7. The relay of inclusion of the fuel pump
      5.4.8. Check of giving of the fuel pump
      5.4.9. A fuel tank
      5.4.10. An accelerator pedal
      5.4.11. The fuel filter
      5.4.12. The fuel pump
      5.4.13. Dump of pressure of fuel in system
      5.4.14. The distributive fuel pipeline
      5.4.15. Fuel atomizers
      5.4.16. A regulator of pressure of fuel
      5.4.17. The case throttle заслонки
      5.4.18. The gauge of position throttle заслонки (ДДЗ)
      5.4.19. The idling valve (КХХ)
      5.4.20. Replacement of the case throttle заслонки
      5.4.21. System of compulsory ventilation картера (СПВК)
      5.4.22. Check of functioning of the valve of ventilation картера (КВК)
      5.4.23. System of release of the fulfilled gases
      5.4.24. Katalitichesky neutralizer
      5.4.25. A reception exhaust pipe and каталитический neutralizer
      5.4.26. The forward muffler with an intermediate exhaust pipe
      5.4.27. The back muffler with an exhaust pipe
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

5.4.15. Fuel atomizers
THE GENERAL DATA

Installation of a fuel atomizer

 


The prevention

For reduction of risk of occurrence of a fire and травмирования the personnel it is necessary to replace at each dismantling of atomizers sealing round rings new.


To remove or disconnect

PERFORMANCE ORDER
1. A negative wire of the storage battery.
2. To dump superfluous pressure in fuel system.
3. The distributive pipeline in gathering from a head of cylinders. Dismantle of the distributive pipeline can be made without a detachment of feeding and drain fuel pipelines.

To disassemble

PERFORMANCE ORDER
1. To shift a collar of an atomizer and to deduce it from gearing with nest ledges, to dissolve with fingers a collar and to remove it. The collar is not subject to a reuse.
2. To take out from a nest an atomizer in gathering.
3. To remove about both atomizers sealing rings and to throw out them as rings are not subject to a reuse.

To collect

PERFORMANCE ORDER
1. To grease new sealing a ring with engine oil and to establish them on the atomizer case.
2. To establish a new collar on the atomizer case. The collar should settle down to in parallel electric socket.
3. To insert atomizers in gathering into nests of the distributive pipeline so that collars and electric sockets were outside. To establish an atomizer coaxially with a nest, to enter a collar into gearing with ledges of a nest and then completely to move an atomizer into a nest against the stop.

To establish or attach

See corresponding operation in subsection 5.4.14.

To examine

PERFORMANCE ORDER
To include ignition and, without starting the Engine, to check up tightness of connections of fuel pipelines.