Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
- 10. A five-speed transmission and the main transfer RPO MM5
   10.2. The general description
   10.3. Diagnostics of malfunctions
   10.4. The possible reasons of the raised noise of a transmission
   10.5. Level check трансмиссионного oils
   10.6. Adjustment of a drive of the mechanism of switching
   10.7. The gear change lever
   10.8. The floor mechanism of management of a transmission
   10.9. Draught of the mechanism of management
   10.10. The intermediate lever
   10.11. A speedometer drive
   10.12. A cover of the mechanism of the switch
   10.13. Consolidations of semiaxes
   10.14. Transmissions in gathering
   10.15. Dismantling of a transmission and the main transfer
   10.16. Characteristic malfunctions of a transmission and the possible reasons
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

10.5. Level check трансмиссионного oils
THE GENERAL DATA

Level check трансмиссионного oils

85. THE STOPPER
234. THE STOPPER COVER

The oil channel of a secondary shaft

1. THE OIL CHANNEL

Arrangement of exhaust outlets of oil channels of a secondary shaft

1. EXHAUST OUTLETS OF OIL CHANNELS

To check up

PERFORMANCE ORDER
To establish the car on a horizontal platform, to turn out a stopper 86 and to check up oil level. Transmission should be cold. Normal level of oil corresponds to a bottom edge of a control aperture. Decrease in level of oil to 4 mm below aperture edge is supposed. If oil level недостаточ ный, it is necessary to turn out a jellied stopper and to add трансмиссионное oil дли mechanical transmissions easily soiled 1234537. Oil add prior to the beginning вытекания it from a control aperture. After that to establish to the place of a stopper. In secondary to a shaft of transmission F16 special channels for an oil supply to gear wheels of various transfers and synchronizers are executed. These lubricant channels are shown on fig. the Oil channel of a secondary shaft, fig. the Arrangement of exhaust outlets of oil channels of a secondary shaft. For transmission filling 2,0 l of oil are required.