Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. A forward suspension bracket
   14.2. The general description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Condition check подшипниковых support and spherical hinges
   14.5. The stabilizer
   14.6. A rack in gathering with подшипниковой a support
   14.7. The bottom lever
   14.8. The spherical hinge
   14.9. A nave and the wheel bearing
   14.10. The top support
   14.11. Springs
   14.12. The shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

14.8. The spherical hinge
THE GENERAL DATA

Spring clamp

AND. THE BACK HANDLE
CENTURY FORWARD LOOPS
WITH. CLAMPS

1. THE SPRING CLAMP

To remove or disconnect

Removal of rivets of the spherical hinge


 

PERFORMANCE ORDER
1. To release bolts of fastening of forward wheels.
2. To lift the car.
3. To bring basic racks under the car or under suspension bracket support.
4. To lower it is a little car so that he leant against racks, but not on the bottom levers.
5. Forward wheels.
The prevention

To track that полуось did not leave the internal mobile hinge. It will lead to hinge dismantling. Probably also hinge damage. During work in a zone of an arrangement of hinges of semiaxes it is necessary to use the protective covers which are put on on rubber грязезащитные of consolidation of hinges. Otherwise damage of details or consolidations of hinges and an exit of hinges out of operation is possible.


6. A spring clamp of 1 nut of the spherical hinge 6.
6а. To raise the back handle of a clamp and to take out it for forward loops, fig. the Spring clamp see.
7. The spherical hinge 6 from a rack 33. To use a stripper for spherical hinges KM-507V.
8. The bottom lever.
9. To drill heads of three rivets of fastening of the spherical hinge and to beat out rivets from apertures бородком. For drill вания to use 12-mm a drill.

To establish or attach

Boltovoe fastening of the spherical hinge to the lever


 

PERFORMANCE ORDER
1. The spherical hinge 6 on the bottom lever 13.
2. Three bolts with nuts in apertures of rivets in the bottom lever (instead of rivets). To tighten nuts the demanded moment. Nuts should be established from below the lever.
3. The bottom lever.