Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
- 14. A forward suspension bracket
   14.2. The general description
   14.3. Check of size of forces of a friction in a suspension bracket
   14.4. Condition check подшипниковых support and spherical hinges
   14.5. The stabilizer
   14.6. A rack in gathering with подшипниковой a support
   14.7. The bottom lever
   14.8. The spherical hinge
   14.9. A nave and the wheel bearing
   14.10. The top support
   14.11. Springs
   14.12. The shock-absorber
   14.13. Plugs of hinges of the bottom lever
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

14.3. Check of size of forces of a friction in a suspension bracket
PERFORMANCE ORDER
1. Together with the assistant to undertake hands a forward bumper and to lift car redock, probably, above. Smoothly and slowly to lower the car until it will not come to position of static balance.
2. To measure distance on a vertical from a floor to the bumper middle.
3. To press a bumper from above and to lower car redock, probably more low. Then, smoothly and slowly reducing effort, to give the chance to the car to come to position of static balance.
4. To measure distance on a vertical from a floor to the bumper middle. At a normal friction in a suspension bracket the difference between two результа тами measurements should not exceed 12,7 mm. If the difference exceeds this value, it is necessary to check up a condition of support of the bottom levers, telescopic racks and spherical hinges.