Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
- Transmission
   9.2. The general description
   9.3. Diagnostics of malfunctions
   9.4. A cable of a drive of coupling
   9.5. A coupling pedal
   9.6. Conducted and press disks, a coupling drive
   9.7. Removal of air from a hydraulic drive of coupling
   9.8. The main cylinder
   9.9. The working cylinder of coupling
   9.10. The basic malfunctions of coupling, their reason and ways of elimination
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment



9.9. The working cylinder of coupling
THE GENERAL DATA

The working cylinder of coupling

9. THE WORKING CYLINDER
57. THE ROD
59. THE VALVE FOR AIR REMOVAL
64. THE CAP
65. THE CUFF
66. THE JET
67. THE SPRING
63. THE RETURNABLE SPRING
65. THE CUFF
70. THE PISTON
71. THE LOCK RING
72. THE COVER

To remove or disconnect

PERFORMANCE ORDER
1. To disconnect a hydraulic hose from the working cylinder, having turned on by means of a wrench a bolt 11.
2. To turn out fixing bolts 7 and to take out the working cylinder from an arm 8.

To disassemble

Dismantle of the working cylinder of coupling

7. THE BOLT
8. THE ARM OF THE WORKING CYLINDER
9. THE WORKING CYLINDER
10. THE COPPER WASHER
11. THE BOLT
12. THE HOSE WITH TIPS
59. THE VALVE FOR AIR REMOVAL

Dismantle of the piston from the working cylinder by means of compressed air


PERFORMANCE ORDER
1. To remove a cover 72 from a rod 57.
2. To drown by means of a screw-driver the piston in the cylinder and to remove a spring lock ring (to use nippers-strippers).
3. To take out the piston in gathering. If the piston is not taken out, to bring to an entrance aperture of the cylinder the compressed air and to squeeze out the piston outside.

To remove or disconnect

PERFORMANCE ORDER
1. To grease with a fresh brake liquid the piston 70 and a sealing cuff 69.
2. To establish a spring on the piston and to insert it into the working cylinder.
3. To drown by means of a screw-driver the piston in the cylinder and to insert into a cylinder flute a spring lock ring (to use nippers-strippers).
4. To insert into the cylinder a rod 57 and to put on a cover 72.

To establish or attach

PERFORMANCE ORDER
1. To insert the working cylinder 9 into an arm 8 and to fix its bolts.
2. To insert into an entrance aperture of the working cylinder a spring and a jet, to attach to the cylinder through two copper washers a tip of a hydraulic hose.
The prevention

To grease консистентной with greasing interfaced surfaces of a rod of the working cylinder and the lever of the platen of coupling.


3. After assemblage to remove air from a coupling hydrodrive, to adjust a course of a pedal and to finish level of a working liquid in a tank to norm.