Daewoo Nexia

Since 1994 of release

Repair and car operation



Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
- 16. A back suspension bracket
   16.2. The general description
   16.3. Maintenance service and repair
   16.4. Check of size of forces of a friction in a suspension bracket
   16.5. Bearings of wheels
   16.6. The shock-absorber
   16.7. The stabilizer
   16.8. Springs
   16.9. Plugs of hinges of a back suspension bracket
   16.10. A back suspension bracket in gathering
   16.11. A nave
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment



16.8. Springs
THE GENERAL DATA

The prevention

At replacement of springs of a back suspension bracket not to use the two-rack-mount lift. At dismantle of details of a back suspension bracket stability of position of the car can be broken and falling of the car from the lift is possible. If there is no four-rack-mount lift травмирования the work personnel it is possible to spend to avoidance directly on a floor.


To remove or disconnect

PERFORMANCE ORDER
1. To lift the car and to fix in appropriate way. At possible сти follows опирать lift paws on a car Body. To bring basic racks under levers of a back suspension bracket. At use of the two-rack-mount lift опереть paws on the Body and to bring basic racks under suspension bracket levers.
2. Fastenings left and right трубопрово дов a brake drive to an arm on the bottom of the Body Pipelines should hang freely.
3. To turn away a nut and to disconnect a cable of a lay brake from the equalizer.
4. To disconnect brake hoses and to close their caps or stoppers in order to avoid dirt hit.
5. The right and left bolts of 8 fastenings of shock-absorbers.
The prevention

It is forbidden to dismantle support of shock-absorbers, preliminary without having disconnected brake hoses Otherwise damage of brake hoses is possible.


6. To lower a beam of 26 suspension brackets and демонти ровать one or both springs 28 and-or the top elastic ring 29.

To establish or attach

Before spring installation it is necessary to establish preliminary on glue in the Body nest the top elastic ring 29. The ring should be on a place at lifting of a beam 26 with springs 28 in assembly position.

PERFORMANCE ORDER
1. The top elastic ring 29, the bottom buffer 27, a spring 28 and to lift a beam 26.
2. The bottom eyes of shock-absorbers 7 to arms of levers. To tighten bolts 8 moment of 70 Nanometers. Before tightening bolts 8, it is necessary to lift a beam of a back suspension bracket in the position corresponding to a static course of a suspension bracket.
3. Brake pipelines to arms on the Body bottom.
4. Brake hoses and to remove air from a brake drive of back wheels.
5. A cable of a lay brake to adjust a lay brake.
6. To remove basic racks and to lower the car.