Daewoo Nexia

Since 1994 of release

Repair and car operation


Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
- 16. A back suspension bracket
   16.2. The general description
   16.3. Maintenance service and repair
   16.4. Check of size of forces of a friction in a suspension bracket
   16.5. Bearings of wheels
   16.6. The shock-absorber
   16.7. The stabilizer
   16.8. Springs
   16.9. Plugs of hinges of a back suspension bracket
   16.10. A back suspension bracket in gathering
   16.11. A nave
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

16.4. Check of size of forces of a friction in a suspension bracket
PERFORMANCE ORDER
1. Together with the assistant to undertake hands a back bumper and to lift a back part of the car probably above. Smoothly and slowly to lower the car until it will not come to position of static balance.
2. To measure distance on a vertical from a floor to the bumper middle.
3. To press a bumper from above and to lower a car back probably more low. Then, smoothly and slowly reducing effort, to give the chance to the car to come to position of static balance.
4. To measure distance on a vertical from a floor to the bumper middle. At a normal friction in a suspension bracket the difference between two results of measurements should not exceed 12,7 mm. If the difference exceeds this value, it is necessary to check up a condition of levers of a suspension bracket on presence of signs of deterioration or damages.