Daewoo Nexia

Since 1994 of release

Repair and car operation

Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
- Cooling system
   4.2. The general description
   4.3. Care of cooling system
   4.4. Thermostat check
   4.5. Check of tightness of system of cooling
   4.6. Plums and filling of system with a cooling liquid
   4.7. The thermostat
   4.8. The water pump
   4.9. The electric fan
   4.10. A broad tank
   4.11. The gauge of a signalling device of an overheat of the engine
   4.12. A radiator
   4.13. Diagnostics of malfunctions of system of cooling
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
+ 15. A drive of forward wheels
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


4.6. Plums and filling of system with a cooling liquid
1. To put under the car the pallet for gathering ОЖ.
2. To uncover a broad tank.
3. To weaken a collar of the bottom hose of a radiator and to disconnect a hose from a branch pipe of a radiator or to open the drain crane.
4. To collect ОЖ in the pallet.
5. To remove, wash out and establish into place a broad tank.
6. After full plum ОЖ to attach a hose to a radiator and to fix a collar, to close the drain crane if it has been opened.
7. To fill in through a mouth of a broad tank pure water. To fill a tank slowly that the top hose remained constantly above a water level. It is necessary for an air outlet from cooling system.
8. To start the Engine and to warm up it to the temperature corresponding to opening of the valve of the thermostat. Thus water will start to circulate through a radiator and radiator hoses will heat up.
9. To switch off the Engine. To repeat operations with 1st on 8th some times while merged water becomes pure and without colour of a rust.
10. To fill in about system through a mouth of a broad tank fresh ОЖ. ОЖ should contain a minimum of 50 % этиленг ликоля. Concentration этиленгликоля more than 70 % is not supposed. To fill a broad tank to a label the MOVE.