Daewoo Nexia

Since 1994 of release

Repair and car operation


Daewoo Nexia
+ The maintenance instruction
+ Maintenance service
+ The engine
+ 3. The engine (two top camshafts)
+ Cooling system
+ Топлевная and exhaust systems
+ Electric chain
+ 7. Ignition system
+ 8. The electronic block of management and gauges
+ Transmission
+ 10. A five-speed transmission and the main transfer RPO MM5
+ 11. Automatic Transmission
+ Steering
+ Running gear
+ 14. A forward suspension bracket
- 15. A drive of forward wheels
   15.2. The general description
   15.3. Kardannye shaft in gathering
   15.4. An external reflective ring
   15.5. A cover of the external hinge
   15.6. The external hinge
   15.7. A cover of the internal hinge of type "Tripod"
   15.8. A cover of the hinge of type "Lebro" with cross flutes
   15.9. Consolidation карданного a shaft in картере transmissions
+ 16. A back suspension bracket
+ Brake system
+ Body
+ Heating, ventilation
+ Electric equipment


1cb365f7

15.5. A cover of the external hinge To remove or disconnect

Dismantle of the hinge from a shaft
TO UNCLENCH THE SPRING RING AND TO REMOVE THE HINGE FROM THE SHAFT

2. THE HINGE CASE
6. THE SPRING RING

PERFORMANCE ORDER
1. With the help бокорезов to remove collars 7, 9, fixing V.Homuty's protective cover выбрость.
2. To disconnect a cover from the case 2 hinges and to shift a cover along a shaft 10, completely to open the hinge.
3. To wipe superfluous greasing from a fist 4 hinges.
4. To dissolve a spring ring 6 by means of a stripper and to remove the hinge in gathering from a shaft 10.
5. A protective cover свала 10.
6. To disassemble the hinge and to wash out details before establishing a new cover.

To establish or attach

Hinge installation on a shaft

2. THE HINGE CASE
10. THE SHAFT

Fixing of a collar of fastening of a cover

 

PERFORMANCE ORDER
1. A small collar 9 on a mouth of a cover 8. Not to suppose formation of folds of a mouth of a cover.
2. To put on a cover 8 a shaft 10 and to establish into place so that a small mouth of a cover it has appeared in a flute.
3. To clamp a collar 9 by means of adaptation DC53007.
4. To enclose in a cover 8 about half of total of greasing of the hinge. With remained greasing to fill the hinge.
5. To put on the hinge a shaft 10 and to shift before fixing by a spring ring 6. The last should sit down in an assembly flute on a shaft 10.
6. To close a cover the case 2 hinges and to place a cover mouth in a flute on the case.
The prevention

Not to suppose перекручивания a cover 8 and formations of assemblages.

7. The big collar 7 on a mouth of a cover and to fix a collar by means of clip KM-J-22610.